DETAILS THAT MAKE A DIFFERENCE

AERONAUTIC PARTS PRODUCED BY FINETORNOS ARE USED IN VIRTUALLY ALL AIRCRAFTS.

We develop and manufacture machined, productive, structural and mechanical parts such as: hardmetal flap panels, hardmetal pylon ribs, frames, supports, coatings, reinforcing plates, lock pins, platforms, ironworks, rails, chutes, connections, plates, forks, actuator support assembly, spindles, sector seam, ramp guide, rods, anchor plates, dowel stabilizer, triggers, cams.

We complement the supply with special assembly processes of sets and subsets with sealing, gluing, flange nut attachment, installation of inserts and helicoil (screwed insertion), ball joints and bearings attachment, combined with other garage practices for manual assembly with or without interference through cryonics, heating by oven and bending with controlled loads.

We manufacture parts for commercial aviation for the Embraer series airplanes, generation 1 airplanes (E1): 170, 175, 190 and 195 and generation 2 airplanes (E2): 175 , 190 and 195 with capacity for 70 to 144 seats.

Executive aviation for the airplanes Legacy 450, 500, 600 and 650, Phenom 100 and 300E, Lineage 1000E and the new Praetor 500 and 600.

Military aviation for the airplanes: cargo ship C-390 Millenium and the light attack turboprop and Super Tucano trainer.

The aeronautic parts manufactured by Finetornos are used everywhere in the aircrafts, such as: Triggering, Doors, Entry Ramps, Flooring, Wings, Flaps, Pylon Boxes, Engines, Fuselage, Cabin, Landing Gear, Stabilizers, Seats, Door Parts, Avionic Supports, Coatings.